Empire P)-1 Owner's Manual download pdf (Page 12)

29210-0-0911Page 12

INSTALLATION(continued)

10. The nished wall surface materials must be non-combustible

for a distance of at least 12” above the top of the replace

outer cabinet.

11. It is recommended that the Junction Box be installed and

properly wired whether or not the optional blower accessory

is installed. Caution: Wiring must be performed by a qualied

electrician.

VentPipeClearance

Note: Maintain one inch (1”) of clearance around vertical vent

pipe. See Figure 11. For horizontal vent, maintain a minimum 1”

clearance to the bottom and sides of the vent, and 3” clearance to

combustibles above the vent pipe. See Figure 12.

WARNING: WHEN FINISHING THE FIREPLACE, NEVER OB-

STRUCT OR MODIFY THE AIR INLET/OUTLET OPENINGS IN

ANY MANNER. PROVIDE ADEQUATE CLEARANCES AROUND

AIR OPENINGS.

CAUTION: PRIOR TO INSTALLATION, MEASURE THE FIRE-

PLACE AND VERIFY FRAMING REQUIREMENTS, METHODS,

AND WALL COVERING DETAILS PRIOR TO FRAMING CON-

STRUCTION.

CAUTION: If the joints between the nished wall and the

replace surround (top and sides) are sealed, a 300°F minimum

sealant material must be used. These joints are not required to be

sealed.

SurroundInstallation

To complete the installation of the Loft replace, a Surround Kit

specically designed for use with these replaces must be in-

stalled prior to use. Surround options shown on page 38 are avail-

able from your dealer. Follow the instructions included with the

Surround Kit for proper installation.

OptionalBlowerAccessory

The Loft replace may be equipped with an optional FBB8 blower

accessory. See page 38.

The blower accessory may be installed at any time before or af-

ter installation of the replace providing that the junction box has

been properly pre-wired and secured to the right hand side of the

replace outer wrap. See Figures 10, 43 and 44.

Caution: Wiring must be performed by a qualied electrician.

Note: For shipping purposes, the junction box is installed on

the inside of the outer replace wrap. It is secured with

(2) screws on the side of the replace. Once removed

from the side of the replace, wiring to the junction box

and recepticle can be performed. Re-install the junc-

tion box assembly to the side of the replace so that the

recepticle faces insward. See Page 11, Figure 10.

TopofVent

Combustibles NOT

allowed in shaded

area

(25 mm)

7” Diameter

intake vent

4” Diameter flue

(25 mm)

(76 mm)

Figure 12

1” MINIUM AIR SPACE

CLEARANCE AROUND

VENT PIPE

Figure 11

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments

Empire P)-1 Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Fireplaces Empire P)-1